If you decide to permanently swap to another edition – no problem. We also will offer faceplates separately. But you can dump any edition into the programmer, so you can safely try out all the others. The Matrix does not have any Wave Envelope and the Microwaves Oscillators have no Crossmodulation e.g. This would not make any sense – the faceplate would not match anymore. It is NOT possible to swap the editions directly on the programmer. The Synth Programmer will be offered in 5 Editions, each carefully designed and programmed to get the most of the targeted synthesizer. The kit is complete: all parts, pre-programmed MPU, knobs and a tough steelcase with faceplate. For the DIY kit we will offer a pictured building instructions PDF.
#FREE OBERHEIM MATRIX 1000 EDITOR MANUAL#
All your learnt chords will be saved automatically and are instantly available after the next powerup.Įach Synth Programmer comes with a decent, detailed, printed operation manual in english. The Chord Memory of the Synth Programmer does not only memorize one chord, it offers five, each with it’s own strum delay! These five ‘Chord-Slots’ can be swapped quickly by midi notes to play or automate the most complex chord progressions. A learnt chord (up to 6 notes) can be transposed on the keyboard by pressing just one key. We therefore thought it would be nice to integrate one in the Synth Programmer. One feature we always loved on vintage synthesizers is the Chord Memory. The remainings are clustered in groups and quickly accessible over display and encoders.
The 45 most important parameters are assigned directly to pots. You can tweak the sound while the sequencer fires notes into the synth at the same time. Incoming Midi data will be merged with the parameter changes from the frontpanel and will be sent together into your synthesizer. Of course the programmer has a second MIDI IN jack to be connected to your DAW or sequencer. On turning a knob the display shows – besides the new – also the ‘old’ value for targeted, non-destructive editing. The programmer will be connected to your synth in a loop (MIDI IN to MIDI OUT and vice versa) for both to use the same initial patch-parameter values.
More about the available editions in the tab ‘EDITIONS’. The Synth Programmer will be available in several editions, each highly specialized and optimized in visual design and firmware to get the most out of the supported synthesizer. High quality electronic parts in a tough and cute steelcase Made in Germany. It allows direct access to all parameters of your favourite music synthesizer – with 45 pots, 4 endless dials, a 2×16 character display and 7 old-school pushbuttons. The Stereoping ‘Synth Programmer’ is the next logical step after our successful Synth Controller.
0 kommentar(er)
